Specifies the selection method to be used in the draping operation.

Defines the thickness of the selection volume (Slab or Prism). Tip: dynamically measure on the point cloud to set this parameter by clicking on the icon.

Extend the geometry computed by the specified scale factor. Tip: extending planes may simplify the further adjustment of connected planes using Trim Surface tool.

Constrain the output to be either Vertical or Horizontal if the deviation is within a tolerance. The tolerance is an angular value in degrees defining the maximum deviation of the plane to consider the Horizontal\Vertical constraint.

Use the ACS direction as the main direction to constrain the normal.

Use all attached point clouds during processing.